SAE Cartridge - 350 bar
NC Single Lock Pilot Operated - Poppet Type
Solenoid operated, 2-way 2-positions, normally closed, piloted
poppet type, screw-in cartridge valve.
Typically used as a blocking or load holding device for high pressure
circuits. When the coil is de-energized, the SVT0.S10 acts as check
valve allowing free flow from 1 to 2, while blocking from 2 to 1.
When the coil is energized the poppet lifts and opens both the 2 to
1 and the 1 to 2 flow paths.
The rigid design using a 1-piece body contributes to minimize the
effect of eccentricities in cavity and provides great reliability.
Low pressure drop thanks to optimized flow path.
All external surfaces are zinc plated and corrosion-proof.
All valve parts are made of high strength steel. Poppet is hardened
and ground to ensure minimal wear and extended service life.
Coil seals protect the solenoid system.
Manual override options.
Industry SAE common cavity.
This product is no longer in stock
Warning: Last items in stock!
|Maximum operating pressure||350 bar|
|Maximum flow||80 l/min|
|Internal leakage||max 5 drops/min @ 350 bar|
|Response time||Energized 30 ms, De-energized 50 ms (typical 24V DC coil)|
|temperature||-30°C to 110°C|
|fluids||Mineral-based or synthetics with lubricating properties at viscosities of 7.4 to 420 cSt|
|Minimum pull-in voltage||85% of nominal|
|installation torque||55-65 Nm|
|seal kit code||SK.032 and SK.027 (coil)|
NOTE: The performance chart illustrates flow handling capacity in both directions (1 to 2 and 2 to 1, both energized). P/Q curves are recorded at TOil = 40°C and 46 cSt